BikeMaster Shock Spanner Wrench

$6.99 (22% off)
3.80 out of 5 stars
In Stock - Ships Tomorrow!
BikeMaster Shock Spanner Wrench
BikeMaster Shock Spanner Wrench
  • Description
  • Reviews (4)
  • Q&A (1)
  • For most easily accessible shock collars or steering head nuts.
3.8 out of 5 stars (4)
3.8 out of 5 stars
5 star   1
4 star   1
3 star   2
2 star 0
1 star 0
See Terms and Conditions
1-4 of 4
Overall 3 out of 5 stars
Top 1000 Contributor Verified Purchaser
Location: Nj
Good tool to have around

I purchased this tool to tighten my suspension on my grizzly 660 and could not get it to tighten. Mayby cause their stuck on not 100 percent sure. Besides it not working on my grizzly the tool is constructed well and I will be using it on my dirtbikes instead of using a screwdriver.

Overall 4 out of 5 stars
Verified Purchaser
Location: Southwest VA
Needed a little modification...

I ride a VTX 1300C and found it wouldn't fit in the holes on the shock. I just ground the end down until it fit and it worked fine.

Overall 5 out of 5 stars
Verified Purchaser
Location: Hawaii
Right tool for the right job

Nothing is worse then ruining the shock spanner nut with a punch and hammer. Use the right tool!

Overall 3 out of 5 stars
Verified Purchaser
Location: Sterling, VA, USA
Difficult to use

There isn't much substance to it, and it feels like it will break easily. Plus it was hard to use since it's so thin. But ultimately it did the job, and it's not like I'm going to be constantly adjusting my shocks, so I can't complain too much.

1-4 of 4
Total Questions (1)
Questions with answers:
Questions without answers:
1-1 of 1
islandbikes 2 months 19 days ago Location: Hawaii, USA
Fit a 2003 yamaha R1?
Has a 40-42 mm steering head nut, will this work? thank you!
MotoSport Staff Expert
2 months 18 days ago
The Bikemaster Shock Spanner Wrench Fits 8, 10, and 12mm steering head nuts.
1-1 of 1