BikeMaster Arrow Head LED Turn Signal

$26.99 (21% off)
3.00 out of 5 stars
  • Description
  • Reviews (2)
  • Q&A (4)
  • Lightweight ABS construction.
  • Waterproof wire grommets.
  • Super bright LEDs.
  • Rubber anti-vibration mounts.
  • Plated hardware for long life.
  • Sold in pairs.
3.0 out of 5 stars (2)
3.0 out of 5 stars
5 star   1
4 star 0
3 star 0
2 star 0
1 star   1
See Terms and Conditions
1-1 of 2
Overall 1 out of 5 stars
Location: Boston, MA
Poor Quality

These blinkers look great and are nice and bright however they are poor quality. While tightening the bolt to the blinker, the metal threads ripped right out of the blinker. It was barely even hand tight when it broke.

1-1 of 2
1-4 of 4
PeterrrMan Over 11 months ago Location: Illinois
What's the diameter of the threaded portion of the turn signal that would fit through the existing hole on my motorcycle?
Top 1 Contributor
Over 10 months ago
BikeMaster Arrow Head LED Turn Signal uses a Stud: 8mm x 1.25" thread pitch
JBROOM 1 year 8 months ago
How do you fit these with the Resistors to get wiring correct?
I have a Honda CBR 1000RR 2008 model and i ordered these from you and i can't get them to work. I bough the resistors too and i am not sure if i am wiring them wrong. Help would be appreciated
Top 1 Contributor
Over 10 months ago
Resistors are to be wired inline on one of the leads from the turn signal. Depending on your application, you may need additional parts to convert to LED turn signals such a special turn signal relay.
kelly 1 year 11 months ago
Can i put this on a 2008 shadow? Does it flash red or amber? Do I need a colored lens?
MotoSport Staff
1 year 11 months ago Location: Portland, OR, USA
These would not be a direct bolt on for the 2008 Honda Shadow Spirit. The mounting for the stock signals is a different configuration. The rear signals would be easier to install and would require you to enlarge the mounting hole for these to fit. The front would require more work as the stock front signals are integrated into the mounting clamps on the forks. It would require new mounting brackets to get these to fit on the front. These signals will blink amber and do not require different lenses.
ihsmith 2 years ago
If you put this on a stock 1999 honda cbr 600f4 do you need a resistor for it to work correctly or can you just plug it in and it will function right?
MotoSport Staff
2 years ago Location: Portland, OR, USA
You will need resistors to control the flash rate. The 1999 CBR600F4 did not come with led signals stock.
1-4 of 4