For a limited time, purchase a Bell Vortex Helmet and get an additional FREE Bell ClickRelease Face Shield! MotoSport.com makes it easier to get the helmet you need with the shield flexibility you want!
The Bell Vortex Helmet:
Velocity Flow Ventilation system with FlowAdjust for maximum stability and temperature control with minimal noise and buffeting.
Lightweight composite polycarbonate alloy shell.
Contour cheek pads.
Removable and washable, antibacterial/antimicrobial interior comfort liner.
Padded wind collar to drastically reduce wind/road noise.
Integrated speaker pockets for audio speakers.
ClickRelease for the fastest, easiest, tool-free shield swaps ever.
NutraFog II superior anti-fog, anti-scratch and UV protected shield.
Padded chin strap with D-ring closure and strap keeper.
Helmet shown with dark shield - sold separately. Clear shield included.
Five-year manufacturer warranty.
Meets or exceeds SNELL and DOT standards.
Weight: 1600 grams.
The FREE Bell ClickRelease Shield:
Replacement face shield for Bell Star (2015 models and earlier), Vortex, RS-1, Revolver and Qualifier helmets.
3Mode shield for instant on-bike shield adjustments, and ClickRelease for the fastest, easiest, tool-free shield swaps ever.
Features Bell's exclusive NutraFog II anti-fog, anti-scratch and UV-protected coating.
Race versions have posts for tear-offs (tear-offs sold separately).
Note: Compatible only with Bell ClickRelease shield system.
Bell's 3Mode Shield allows for one-finger toggling between Lock Mode, Friction Mode and Crack Mode. Lock Mode is the shield's firmest and quietest setting. It not only locks down the shield, but pulls it tightly to the gasket, creating a water-tight seal. The Friction Mode allows the shield to be freely adjusted from fully closed to fully open and anywhere in between. Crack Mode disengages the shield from the gasket and lifts it about 1/4" to help prevent fogging, a particularly useful setting at stop lights. A quick touch of the 3Mode Lever brings the shield back into Lock Mode.
ClickRelease was designed for the quickest, easiest shield swaps ever. To remove, simply fully open the shield and depress the ClickRelease Triggers. For installation, just align shield pivots in the fully open position and push until they click into place.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.