asked 1 year, 8 months, 8 days ago by nonickname, on CYCLE COUNTRY HEATED GRIPS
Normally all the wiring for the heating system is in the main part of the grip not on the end where your bar end mirror would go. You would most likely need to cut the end of the grip off in order to run the mirrors. I would contact Cycle Country to see if any other modification is required.
800.841.2222
answered 1 year, 7 months, ago by Drewski, Portland, OR
Where is a wiring diagram for hot grips?
asked 1 year, 6 months, 19 days ago by BigDaddyone, on CYCLE COUNTRY HEATED GRIPS
This is a link to the manual that comes with the grips.
http://www.cyclecountry.com/Portals/0/sitePDFs/50-0360.pdf
answered 1 year, 6 months, 17 days ago by Drewski, Portland, OR
can you wire these up to a 2002 banshee
asked 10 months, 20 days ago by , on CYCLE COUNTRY HEATED GRIPS
Yes you could easily wire it up to an aux switch or to the lighting coil
answered 10 months, 19 days ago by sandstyle82, surprise,az
do u just run the wire to the battery without coverin the wire or does it have covers for them
asked 8 months, 11 days ago by ra57, on CYCLE COUNTRY HEATED GRIPS
You would need to route wires in protected\safe areas zip tying as you go, and could go to your local auto parts store and buy some split loom to make for a clean install.
answered 8 months, 7 days ago by Ted932, Lynden, WA
i have a twist throtle and that grip is larger that the left side grip. would it break the grip if it doesnt fit?
asked 8 months, 9 days ago by gstein, on CYCLE COUNTRY HEATED GRIPS
These will only fit ORV without twist throttles.
answered 8 months, 7 days ago by Ted932, Lynden, WA