The RP60 represents the proposal of the AGV range dedicated to vintage style. Reflecting its tradition for unmistakable style that its riders (a perfect example being Renzo Pasolini) have taken on the racetrack in the past, AGV updates the characteristics to create a product which is sure to interest those in search of a helmet with the pure spirit of motorcycling.
The design of the RP60 is absolutely faithful to those used in the '50s and '60s, characterized by a clean, rounded shell, on which there are three press studs in the front area and a ring to hold the goggles on the back. Edges and coverage of polystyrene in faux leather accentuate the vintage effect and further enhance the product.
ACF (Advanced Composite Fiber) fiberglass shell.
One shell size.
Dry-Comfort with sanitizing treatment fabrics.
Removable and washable internal padding.
Double-D fastening system.
Weight: 960 grams ( 50 grams).
Transparent tinted peak included.
Write a Review
Enter to Win $500
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye-brows and across the largest portion of the back of the head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.