What can I say? Ordering was easy, shipment was fast and the part is a must have for anyone looking to do away with that gawd awfull rear fender contraption. The kit has everything you will need to install onto your bike. Instructions are clear enough, the brackets are nicely made with a quality black finish. All I would suggest is to take your time. With my particular bike I had to disassemble the whole right rear side of the bike to get at the wiring (2012 ZX6R) no fault of the kit, this is more coming from a DIY'er point of view to go easy. Don't be scared to do it yourself just take your time and give yourself a couple hours to complete the installation. 'Cause in the end your gonna love the look as much as I did mine. Oh and I reused the stock signals. Just remove the rubber extension piece from the signal (as the instructions state) and they're good to go. With the extensions gone they sit on the bracket nicely and don't protrude out the sides. I think they look factory, but nicer. Should have been made this way IMO.