Perfect fix for the connecting joint between pipe and silencer. Seals on tight and stops oil from blowing out. Infinitely better than OEM rubber boot!
TM Designworks No Leak Exhaust Collar
- 13 Reviews
- 5 Questions
TM Designworks created a solution to keep the smoke from a 2-stroke moving through the silencer end cap with the No Leak exhaust collar.
- Fitted with an internal military-spec O-ring that expands at high heat, creating a perfect seal.
- For extreme durability and longevity, constructed out of billet aluminum.
- Will fit most pipes (excludes Duncan Fat Boy pipes).
Works Great , but had a tough time getting it on my exhaust
Works better than the rubber oem one. Still lets a little spooge out of my fatty/shorty.
Absolutely awesome exhaust collar. Fit easy and works great. When the bike is warm you'll have a airtight seal with no residue leaks, When it's cooled down you can easily remove the silencer. Far exceeds the stock rubber boots! No more scrubbing away dripping spooge! Highly recommended!
This collar fits tight on my 2003 yz125 stock exhaust and has stopped all leakage. It was easy to put on and saves me a lot of time cleaning the bike after riding. I would definitely recommend this if you are sick of dealing with a leaky exhaust. Worth the money.
I have this collar installed on my 2000 Honda cr250 with fmf fatty pipe and turbine core silincer. It fits perfectly. No leaks and stays in place. Just needed a little vaseline on the inside to help it slide on easier.
It installs easily, and looks good, but mine started leaking after the second ride! At least it wont tear like the stock rubber one...
Bought this for my 2004 CR250 since the OEM rubber one ripped...def recommend this to anyone with a CR 2-stroke or any bike that has a problem with the exhaust leaking between the expansion chamber and the muffler.
This product didn't fit my 2005 Suzuki RM 125 It pushed my silencer about half an inch to far out from the mounting bolt. Had to use a dead blow hammer to install it all the way on for the tight fit and the silencer still didn't line up. Idk if its cause i have the FMF SST pipe and not the Fatty but i wasted 36.99!!!
a must have for any two stroke. had this for over three years on my cr and does just as stated. no hi temp silicone needed a bit tough to get on the expansion chamber but a little bit of light lubricant and went on easy and complete exhaust install was not affected. once on, exhaust leak was gone & looks way better than the factory black rubber that was worth less.
I've had these product on my 07 YZ250 for 4 years now. Works like it's supposed to. Hi-temp silicone wasn't used in the application. I'm pleased with this item.
I got this collar as a solution to leaking too much spooge from the pipe connection on the exhaust of my RM. Once attached the silencer no longer lined up with the mounting bolts making the exhaust very difficult to attach. Then my exhaust started leaking spooge again right through the "leak proof" collar. Waste of money. I ended up removing the collar and leaning out my fuel mix ratio instead...