Super simple to use, but still a little messy. Open the jaws, slide the cable in, clamp it down, stick the straw of your favorite lubricant in the hole in the side and spray until bored. There will be a bit of cleanup afterward, but it's less messy and more convenient than the old paper funnel method.
Motion Pro Cable Luber
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!Write Your Review
works well, easy to loose, so now I have 2 , found the other one after I ordered a new one. Good product.
This worked well for me. You need to clamp it on properly and wrap it with a rag to avoid dripping. I applied lube it multiple short sprays and flushed and lubed cable as expected. Nice product
I bought the motion pro cable luber hoping it would fix my sticking throttle cable. I mounted the cable into the luber and spayed lube into the tool. It shot oil everywhere except for in the cable after half a can a lube , the oil never came out of the other end of the cable .The cable feels the same and is still sticking. It would have been easier and much less messy with out the motion pro cable luber. I wish I would have bought a new cable instead of this "tool".
At first I didn't know how to use it but realized it was easier than I thought and use it without a problem. This cable luber helps the lube flow through the jacket with ease and within seconds it will come out the opposite end, letting you know you're done. If you can't figure this out there is a video on YouTube to show you how to use it.
This product worked just ok for me. It doesn't come with any instructions so it takes a little trial and error to get it to work. It doesn't seal up very well, so lube gets everywhere. This is a tough job, but this tool really didn't make it much better in my opinion.
It generally does the job but it does not seal as well as I expected. Make sure you have a rag around or the lube runs out all over everything.
easy application onto new cables or old, and lubes the lines pretty good, only downfall is theres a lot of lube that gets out where the tool installs n gets all over, so have a shop rag or towel wrapped around it n on stand by for clean up excess
The Motion Pro Cable Luber eliminates the mess of trying to directly lubricate cables with the convention straw found on most lubricants.With the cable luber the process is quick and efficient.
WHEN INSTALLED TO THE PROPER SIZE CABLE END IN TOOL IT WILL WORK. POOR RESULTS WITH THROTTLE CABLES ON CRF LEAKS MORE ON THE FLOOR THAN YOU GET IN THE CABLE. WASTED ROOM IN THE TOOL BOX !
I purchased this without really knowing how to use it, and like most products they come with some sort of instructions...not this though. Once I watched a video on the web on how to do it, it did seem to do its job well.
I bought this product bc it wasn't that much and figured it would make lubing my cables easier. Well it turns out that it works. One problem I have is that in order to use it I have to completely remove my cables from clutch/throttle housing. The other problem is that on my throttle housing the luber doesn't get a complete seal bc of threads on the end. So when all is said and done this product is unnecessary and doesn't really make life any easier. It works but so does sticking my red straw into the cable hole and lettin er rip. don't buy this unless you like gizmos or need to buy one more thing to get free shipping. :)
There have been no questions asked about the Motion Pro Cable Luber.