If you ride in the woods. Theses are a def need. Not a want
- 15 Reviews
- 10 Questions
Cycra is an American designer and manufacturer of motorcycle plastic and billet components for off-road, motocross, ATVs and Super Motard racing. Cycra is best known for its innovative products such as the Probend handguards, Cycralite fenders, vented number plates, bodywork and adjustable Moto stands. Cycra components are raced by factory teams and racers such as Factory Yamaha, Factory KTM and Factory Connection Honda.
- Replacement Enduro handshields.
- Injection-molded high-impact plastic.
- Installation hardware included.
very strong, very hard to break
Nice easy way to spruce up the look of your bike. The previous owner of my CRF450X had been down a lot apparently, as the shields were pretty shot. But no more!
The Cycra Pro Bend Classic Enduro Replacement Shields are nice and do fit the frames of the guards pictured. However, they are NOT the guards pictured (which is what I had). Not a big deal, but something to be aware of. The replacement shields that are shipped are asymmetric - with a bit more of the guard above the mid line. NOTE: the guards pictured are symmetric.
I love the protection for my hands and for the levers!
When its time to replace, these are the cheapest ive found. I dont think its actually the one in the picture, still looks great!
I am vary pleased with the service I received here
these are the best offroad handguards..period...ground spills, endos, 20 mph tree hits...no problem..still going strong after a lot of torture..wish i was a hardy as these guards...
installs in minutes
would buy again
I run Cycra Pro Bends on all of my bikes. They are the industry standard. They installed very easily on my Magura oversized bars. I opted to add the orange sheilds, and they look awesome. Trees don't stand a chance now!!!
These guys come in tons of colors which is nice. They come with new screws to attach them to the guards (which you need since the guards are pre drilled but not threaded).
These hand guards are huge and seem like they will do the job if they fit. First of all the red does not match the color that the 2005 yamaha raptor 660r has. And second these hand guards do not fit at all on the stock handle bars on my quad. If my friend had non-stock handlebars i would recommend these to him\her otherwise i wouldnt. Besides that they look very good and seem like racing hand guards.
the best !
i wont use any thing else.
The absolute necessity for any woods rider. Saved my hands a many of times.
Although the CYCRA look great the fit is extreamly poor for Pro Taper or Twinwall bars. I had to use a grinder to make them fit. The Acerbis went on so much eaiser and fit perfect.
The Pro Bend handsheilds are great because if they get thrashed, you can just swap out the plastic for about $20 versus ordering all new hand guards and mounts.