For orders of $49.00 or more
Orders over $49.00 will receive free 3-day express shipping. This is a residential delivery service, with deliveries Monday through Friday from 9:00am to 8:00pm.
Everything is ok, Perfect fit, excelente Look. Really light.
5 out of 5 stars
Sizing - Fit true to size?
Over 7 months ago
The fitment chart was accurate, the helmet is light and comfortable with a good field of vision.
3 out of 5 stars
Sizing - Fit true to size?
Over 9 months agoLocation: Houston, TX, USA
Not Very Comfortable, but durable
There are plastic tabs on the inside lining that push into your forehead. Not noticeable after wearing for a minute or two but its annoying when you first put it on. Also, the ear cushion pieces stick out and rub my neck a little, thats a little funny. My HJC helmet is more comfortable.
The description says 3EPS liner sizes, were these supposed to be included? I just received the one I ordered and there were no additional liners?
Top 1 Contributor
Over 9 months ago
No. The Bell MX-2 helmet comes with 1 liner for the size of helmet you ordered. it is stating there are optional sizes you can order for a custom fit for you.
Over 9 months agoLocation: Columbus
This is not the case. I just got off the phone with Bell and Stephanie in customer service said only 1 size liners are available. The size of the helmet is the size of the liner. Also, cheek pads are available but again, only for the size of the helmet you have. In other words, a 30mm cheek pad is available, but only in XL, it won't fit in a small. Confusing!
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.