AFX FX-17 Youth Trap Helmet

This Purchase Qualifies For:

 
  • Description
  • Reviews (0)
  • Q&A (1)
  • Sizing Chart

This helmet model meets or exceeds both ECE 22.05 and DOT FMVSS-218 motorcycle helmet safety standards.

  • An aerodynamic shell design constructed using an advanced lightweight composite poly-alloy.
  • This helmet is specifically designed to fit adolescents and small adults.
  • A helmet liner and cheek pads made with a hypo-allergenic and antimicrobial nylon, all of which are removable and washable.
  • Includes a removable screw-on visor.
  • 11 points of ventilation with chin, side, forehead top and rear vents.
  • YLS (Youth Liner System): This helmet can be converted to any of three youth helmet sizes through the simple swapping of liner components.
  • Goggle strap grabbers are provided.
  • A square type D-ring with chin strap holder.
  • A clearcoat finish to protect paint and graphics.
  • Comes with a Limited Lifetime Warranty.
  • Weight: 1.24 kg or 2.73 pounds (Large).
  • Please Note: Only ECE approved helmets purchased from European importers carry the ECE certification markings. This is due to ECE regulations.
Total Questions (1)
Questions with answers:
  1
Questions without answers:
0
1-1 of 1
Robert 2 years 2 months ago
Does the helmet come with the three different sized liners?
MotoSport Staff
2 years 2 months ago Location: Portland, OR, USA
MotoSportExpert
This helmet will only include one liner that corresponds to the size you select for the helmet when ordering.
1-1 of 1
AFX HELMETS ADULT
SizeHead CircumferenceHat Size
X-Small 21 1/4" - 21 5/8" (54 - 55 cm) 6 3/4 - 7 7/8
Small 22" - 22 7/16" (56 - 57 cm) 7 - 7 1/8
Medium 22 13/16" - 23 1/4" (58 - 59 cm) 7 1/4 - 7 3/8
Large 23 5/8" - 24" (60 - 61 cm) 7 1/2 - 7 5/8
X-Large 24 3/8" - 24 13/16" (62 - 63 cm) 7 3/4 - 7 7/8
2X-Large 25 3/16" - 25 5/8" (64 - 65 cm) 8 - 8 1/8
3X-Large 26" - 26 3/8â€ï¿½ (66 - 67 cm) 8 1/4 - 8 3/8
4X-Large 26 3/4" - 27 1/8" (68 - 69 cm) 8 1/2 - 8 5/8
YOUTH
SizeHead CircumferenceHat Size
Small 20 7/8" - 21 1/4" (53 - 54 cm) 6 5/8 - 6 3/4
Medium 21 1/4" - 22 5/8" (54 - 55 cm) 6 3/4 - 6 7/8
Large 21 5/8" - 22" (55 - 56 cm) 6 7/8 - 7

MEASURING INSTRUCTIONS

1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.

2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.

WHEN YOU RECEIVE YOUR HELMET

1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.

2. Once the helmet is on:

  • Check that the helmet inner lining fits snugly all around your head.
  • Check that the top pad presses on the top of your head.
  • Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
  • Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
  • Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.